|
These can be edited and created using Playlist Builder or Notepad. You can save the playlists below by clicking on them and then selecting "Save As.." from your browser menu.
First, you'll need a playlist file that loops the attract loop on power-up of the unit. This file MUST be named ply00000.lst.
This playlist file starts a video named "AttractLoop.mpg" and loops it.
Second, you'll need playlist files for each of the input buttons you'd like to use. These are ply00001.lst, ply00002.lst and ply00004.lst.
ply00001.lst plays "Button1Vid.mpg" and then starts the original playlist with the attract loop over again.
ply00002.lst and ply00004.lst do the same thing except that they start "Button1Vid2.mpg" and "Button3Vid.mpg" respectively.
Corresponding Test videos are:
AttractLoop.mpg
Button1Vid.mpg
Button2Vid.mpg
Button3Vid.mpg
The inputs are located on the DB37 pin connector on the rear of the DVM7400. Files or Playlists are selected and played by using different pins and their associated names. Selecting File #1 (pins 5 & 24) corresponds to:
ply00001.lst (playlist) or
vid00001.mpg (video)
A complete list of pins and file selection be found in the "Parallel Ports" section of the DVM7400 user's manual.
|
Orlando, FL 32835