To synchronize multiple Binloops you must first have an external video sync source such as a Horita BSG-50 connected to each Binloop. Then, select one Binloop to be the master and configure it as described below. The SMPTE output of the master can then be connected to the SMPTE input of the first slave. The SMPTE output of the first slave can be connected to the SMPTE input of the second slave and so on. Each slave must be configured as described below. All of the Binloops are now synchronized because they each have the same SMPTE source and VSync source and are configured properly.
Master Binloop Config
Set Jumper W4 (directly behind the buttons on the controller card) to Sync.
Using the Binloop Config software, configure the SMPTE settings to Generate SMPTE and check the "Genlock to Video" checkbox.
Slave Binloop Config
Set Jumper W4 (directly behind the buttons on the controller card) to SMPTE.
Using the Binloop Config software, configure the SMPTE settings to Read SMPTE.
Add to favorites